Circlip

[amalgamated users from prior forum]

Message originally posted by: Worried
Having spotted a little rust on the circlip that locates the retaining spigot on the transverse locating bush on the off side I decided to replace it. However I seem to recall that when I looked at he prototype on the stand at the Kitcar show that the open end of the circlip faced the rear of the car. I have found it easier to replace it with the open end facing the front. will this affect the performance and security of the clip?

[amalgamated users from prior forum]

Re: Circlip

Message originally posted by: Confused
Give us a clue ?

[amalgamated users from prior forum]

Re: Circlip

Message originally posted by: Knowall
As long as the bifurcated ninge wheel does not lock it's spigot in reverse ratchet mode you might be OK. Watch out for MoT though!

[amalgamated users from prior forum]

Re: Circlip

Message originally posted by: Someone
Hmmmm, definitely a case for closing the Modified page I think...

[amalgamated users from prior forum]

Re: Circlip

Message originally posted by: cautious
then again mabe that circlip is the one holding it all together!!!! better put it back as it was

[amalgamated users from prior forum]

Re: Circlip

Message originally posted by: Anita
I always use a hairclip.