Tweet
Into my garage for a bit more aggro, ( Bad neck) Measured up the new silencer position , then fabricated two new exhaust hangers from 10mm bar and welded them in place, it took a while to get back into stick welding, my old rods had deteriorated, the flux fell off the Orlicon rods, but I found some 2mm rods with a blue flux on them, I think they were my old dissimilar rods, they were ok too, I just needed a bit more ampage from my Micky mouse welder and we were away ( Little carpet fire, not in the car ! ) then cleaned up the area and applied a lick of Hammerite. The ebay man who sent me the wrong size exhaust brackets was very apologetic and soon sent me another set -- er, also the wrong size, so I'll wait till I'm in town and pick up a pair then, so thats it !
If you are an existing member and your password is not working or has expired click here
enter your email address then click on "Forgot password"
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
If you have questions please use the Contact Page for a personal response
If you wish to contribute to our discussions then please consider joining the club - its a mere £18 per year and worth every penny!