How do I stop the crankshaft pulley from going round when I try to undo the large nut (36mm across the flats)
So far I have been fairly gentle with it.
The rubber coupling on the front of the prop-shaft flexes and negates stopping the rear wheels turning (in 1st or reverse gears)
I think tomorrows effort may involve a impact driver and the air hammer.
It is on an Alfa engine but I suspect the solution does not involve the make of engine
So far I have been fairly gentle with it.
The rubber coupling on the front of the prop-shaft flexes and negates stopping the rear wheels turning (in 1st or reverse gears)
I think tomorrows effort may involve a impact driver and the air hammer.
It is on an Alfa engine but I suspect the solution does not involve the make of engine
Comment