Hi all
Once again I am trying to fit the inner wings.
Below is a picture of my wing stays.
There appears to be a couple of versions and mine required you to fix the top to the damper and then line up the wings stays so they were horizontal and then drill hole and bolt through at the bottom.
My question is, did the stays come with the top hole pre-drilled so the siting and drilling of the lower hole would be a doddle.
Or did you have to drill both holes?
The reason I am asking is that I am coming to the conclusion that the stays are set to high.
Hopefully someone can delve into their memory banks and answer the question.
Adrian
20160423_132315.jpg
Once again I am trying to fit the inner wings.
Below is a picture of my wing stays.
There appears to be a couple of versions and mine required you to fix the top to the damper and then line up the wings stays so they were horizontal and then drill hole and bolt through at the bottom.
My question is, did the stays come with the top hole pre-drilled so the siting and drilling of the lower hole would be a doddle.
Or did you have to drill both holes?
The reason I am asking is that I am coming to the conclusion that the stays are set to high.
Hopefully someone can delve into their memory banks and answer the question.
Adrian
20160423_132315.jpg
Comment